Innovations in Communications™ Since 1955

155 Adams Avenue, Hauppauge, New York, 11788-3699 USA
Phone: 800-231-1414 or 631-231-1414 Fax: 631-231-1498 E-Mail:

Wireless Single Channel
Receiver with Latching Contact

The NC267 (NC-267) Wireless Single Channel Receiver with Latching Contact is a digital UHF receiver used with the SF067  Wireless Miniature Transmitter for Tek-CARE® NC110 nurse call systems. It allows the user to place an emergency call by simply depressing the button on the transmitter. This allows users to place calls within areas of a dwelling that are not directly near nurse signaling devices. The latching relay circuit can be reset by pressing the button on the NC267.

The NC267 requires no wiring connections to the transmitter and operates on the 303.875 MHz frequency. It provides a dry, latching, "Form C" relay circuit to integrate with SF100 or IR250 series Patient Stations. A simple, easy-access dipswitch programming method allows for up to 252 individual transmitter/receiver code combinations.


Wireless call reception from transmitter

Digital UHF operation

252 transmitter code settings with easy dipswitch programming

Dry "Form C" NEC Class 2 Relay Circuit


 Dimensions: Height: 3.8" (97 mm) Width: 4.9" (125 mm) Depth: 1.3" (33mm)

Power: 12 VDC, 0.12W Standby and 0.48W Active

Frequency: 303.875 MHz

Encoding Technique: Pulse width A-1 modulation at 250 bits/second; four correct 8-bit words required for activation

Mounting: Surface Metal Bracket, included

PK-151A: Power/Control Unit. Electronic components mounted on a printed circuit board and housed in a rugged aluminum case. One required per system. 9 1/2" H, 2 3/8" W, 2 1/4" D.

PS-30A: 24VAC UL Listed Pigtail Transformer. One required per system

RP-021CM: Custom or Blank Lens Markings. One required per zone (8 for standard NC-150R)

Click for Spec Sheet

Architects' & Engineers' Specifications:

The wireless receiver shall be TekTone® NC267 (NC-267) or approved equal digital UHF receiver as supplied by LEE DAN®.

It shall use the 303.875 MHz frequency for signal reception. No physical wiring connections to the transmitter shall be required to receive a call and the device shall include an antenna and a mounting bracket.  

The receiver shall have a minimum of 252 user programmable code settings, via an easy accessible dipswitch. The receiver, upon receipt of a signal from TekTone®'s SF067 or approved equal, shall actuate and latch an internal relay. The relay shall provide a dry "Form C" circuit with Common, Normally Open and Normally Closed connections, which shall be accessible from a clearly marked terminal strip.

The relay shall be rated for a minimum of 32 VAC or VDC @ 1 amp (NEC Class 2 Circuit). The receiver shall provide a latch-reset button.


| Brochure | Doc | Spec Sheet | User Guide | Manual | Wiring |
This page was last updated July 12, 2012

 Phone: 800-231-1414 or 631-231-1414   Fax: 631-231-1498 E-Mail:

© 2001-2019 Lee Dan Communications, Inc., All rights reserved.